Arcade - Arcade Cabinets - Williams - Defender

DEFENDER

Cabinet measurements provided by:
jbrew

​Spot verified by: William Stillwell ( Hamster/KI4SWY )

Has a cabinet been cut from drawings: YES (See Notes)

Construction type:

3/4" plywood unless specified.

 Estimate Cabinet Accuracy = 96%

What does Cabinet Accuracy mean?

Areas of variation:
Comments from William Stillwell ( Hamster/KI4SWY )

"I would say 99% accurate, issues i found was that the holes are cut at an angle on the back part instead of straight, the width was 100 spot on, angles were very accurate.

I would add a note to 'make sure you cut the template and mark the lines prior to assembly.'

I did have an issue where the template cut outs were not the same size/width of the donor cab i had."

Reference Photo

Photo from http://www.klov.com

Picture of finished cabinet - NA

VCarve Pro Drawing

VCarve Pro (Version 8.024)

Note: .CRV files do not contain tool paths. 
defender.crv
File Size: 300 kb
File Type: crv
Download File


DXF File (CAD file.)

defender.dxf
File Size: 370 kb
File Type: dxf
Download File

Files to Print

The below files are PDF documents of the plans that are printed to scale. These documents can be taken to your local print shop and printed on 36" wide media. The prints can then be applied to the wood and used as a template to cut the side panels of the cabinet.  I have only included the side panels and any other panels that may be more difficult to cut.
defender_to_print.pdf
File Size: 7 kb
File Type: pdf
Download File

Cabinet Art Files

Currently not available

Reference Photos

From William Stillwell ( Hamster/KI4SWY ) cabinet build.


Drawing specific notes

Comments

2/5/2018 - Raised score on cabinet, added comments and pictures.
4/14/2017 - added printable files
5/19/2016 - original post
Last updated 2/5/2018